Al-Sabih Marine Equipment is one of the Largest companies in Kuwait and The Middle East offering more than 12850 items from over 147 manufactuers
             

Contact Us

Tel: (+965) 24835228
           (+965) 24835209
Fax:   (+965) 24819672
WhatsApp:     99270105
E-Mail: alsabihmarine@yahoo.com


   

| |
مضخات مارش بمب للعمل الشاق
For more information Click Here
 
 Centrifugal Sealless Magnetic Drive Pump


تصلح لأكثر من مكيف حسب المسافة


AC-3CP-MD



AC-5C-MD
March Pump's industrial AC-3CP-MD is an American seal-less centrifugal magnetic drive pump ideal for applications. The model is hermetically encapsulated which allows the pump to be run fully submerged or in open air for complete moisture protection. See the parts list for a breakdown of parts. Pumps are not self-priming, lack a suction lift, and thus require a flooded suction. Pumps cannot be run dry because the impeller requires the liquid being pumped for lubrication.
Wet End:: Polypropylene (Front and Rear Housing, Impeller), Buna N
                (O-Ring), Ceramic (Shaft, Thrust Washer), Ceramic Magnet

OPERATION::
Pumps are not self priming and will not produce a suction lift and must be installed with a positive flooded suction. We rely on the liquid being pumped to lubricate the impellermagnet assembly spinning on the stationary spindle. The pump is not to run dry .
Model Max Flow Max Head Power Electrical Inlet Outlet
AC-3CP-MD 10 G.P.M 20.5 ft. .066 HP 230V 50/60HZ 3/4"FPT 1/2"MPT
AC-5C-MD 17 G.P.M 27 ft. .125 HP 230V 50/60HZ 1"FPT 1/2"MPT
• استمرارية التشغيل . • كفاءه بدفع الماء . • عمر اطول . • تصلح لأكثر من مكيف . • .ملاحظه : لا تستخدم بدون ماء تبريد بالهواء

مضخه تعمل على التبريد بالزيت


LC-5C-MD





LC-3CP-MD
March “Orbital” Magnetic Drive Pumps eliminate the conventional shaft seals found in most pumps. This means that there is no rotating seal to wear and allow the liquid being pumped to leak out. The pumping action may eventually fail, however the liquid can never leak out. The Model LC-5C-MD pump can be run totally submerged or can be run in open air for complete moisture protection. The model 5C-MD must be run submerged only.
OPERATION::
Pumps are not self priming and will not produce a suction lift and must be installed with a positive flooded suction. We rely on the liquid being pumped to lubricate the impellermagnet assembly spinning on the stationary spindle. The pump is not to run dry .
ELECTRICAL::
Models are 230 Volt, 50/60 Hz, 1 phase, A.C. The motors are thermal overload protected, and the motor and overload combinations are U.L. and C.S.A. listed. All cord sets are U.L. approved 18/3 wire, SJO or SJT cords.
Model Max Flow Max Head Power Electrical Inlet Outlet
LC-5C-MD 14.5 gpm 27 ft. .125 HP 230V 50/60HZ 1"FPT 1/2"MPT

Wet End: Polypropylene (Front and Rear Housing, Impeller), Buna N
               (O-Ring), 316 Stainless Steel (Shaft, Cooling Tube), Ceramic (Shaft, Thrust Washers), Ceramic Magnet


Model Max Flow Max Head Power Electrical Inlet Outlet
LC-3CP-MD 8.5 gpm 19ft .05 HP 230V 50/60HZ 3/4"FPT 1/2"MPT

Wet End: Polypropylene (Front and Rear Housing, Impeller), Cupric
                Nickel (Cooling Tube), Buna N (O-Ring), Ceramic (Shaft, Thrust Washers), Ceramic Magnet

• قوة ضخ كبيره .
• قابله للتشغيل حتي متر واحد تحت الماء .
• تعمل بالكهرباء 230 فولت .
• قابله للتشغيل في الهواء الطلق مع نسبة رطوبه عالية .
© 2021. www.alsabihmarine.com, All rights reserved